| Transmission Standards |
DVB, MPEG 2 |
| RF input Modulator output |
| In-/output connector |
IEC female / IEC male |
| RF input frequency |
174-300; 474-862 MHz |
| RF input power level |
-78 to -30 dBm |
| RF impedance |
75Ω |
| Frequency range |
Loop through 47-862MHz |
| Frequency range |
RF modulator 470-862 MHz |
| Output channel |
CH 21-69 |
| Preset channel |
43 |
| Output signal |
PAL G/I and SECAM |
| Demodulation |
OFDM 2k and 8k |
| TV SCART |
| Video output |
1 Vpp ( 1 dB) / 75Ω |
| Audio output |
0.5 Vrms / RL >10 kΩ |
| RGB output |
Internal RGB |
| RGB bandwidth |
5.8 MHz 3 dB |
| Fast blanking output |
Internal |
| Status output |
0/6/12 V / RL 10 kΩ |
| AUX SCART |
| Video output |
1 Vpp ( 1 dB) / 75Ω |
| Video input |
1 V pp / 75Ω |
| Audio output |
0.5 Vrms / RL >10 kΩ |
| Audio input |
0.5 Vrms / RL >10 kΩ |
| Status input |
0/6/12 V / RL >10 kΩ |
| DIGITAL AUDIO (S/PDIF) |
| Connector |
1 x RCA |
| AUDIO R L |
| Connector |
2 x RCA (R+L) |
| Output |
0.5 Vrms 0.5 dB/ RL 10 kΩ |
| Telephone (return channel on the phone line) |
| Contact |
modular 6-pin jack |
| Protocol |
V.32 bis |
| Front panel |
Two LED; Buttons "standby", "up" and "down" |
| Conditional Access system |
One slot on the left side for a DVB Common Interface CA
module. The right-hand card slot is intended for a Conax
smart card.
|
| General data |
| The model code, variant and serial number, are located on a
label on the underside of the housing.
|
| Supply voltage |
110-240 V AC, 50-60 Hz |
| Power consumption |
20 W |
| Power consumption in
standby
|
5 W |
| Operating temperature |
+5°C to +45°C |
| Storage temperature |
- 40°C to +65°C |
| Humidity |
25 to 75 % rel humidity |
| distance for
remote control
|
About 10 meters |
| Dimensions (w x d x h) |
250 x 275 x 80 mm |
| Weight |
1050 g. approx. |
